Our design team will visit the site and discuss with the concerned person of the organization to understand their requirements. Our team will study the area and find out the number nodes, distribution of nodes at different departments, floors. They will check the feasibility of wireless at important locations and also discuss the surveillance requirements.
After completing the site visit and getting the required feed back, our design team prepares the network design and the bill of material. While designing they consider the following Points : Whether to keep all network switches at central place or keep at different locations. Choosing suitable physical media ( Cat 6, Cat 6 A) for central and distribution locations and whether any redundant links are required. How to lay the cables through flooring or through false ceiling. To design the size of the metal trays and PVC material to be used. Deciding the size of Communication rack (Wall mount or Floor mount), Server Rack and KVM switch based on number of servers and other equipments. To decide the suitable networking products required. Finally the bill of Material will be prepared
Once design part is over our installation team will install the physical layer products. We have our own team to do the installation. After installation the network will be tested with testing equipments. The Switches will be installed and configured. The complete network will be documented for the support personnel.
Our design team will visit the site / campus ( Factory, University or Public Sector) and discuss with the concerned person of the organization to understand their requirements, like the areas and the buildings to be linked. They will find out proposed number nodes in each building. Our team will find out the distances between different buildings.
After completing the site visit and getting the required feed back, our design team will start preparing the network design and the bill of material. They will decide the type of Fiber to be used, (Multimode, Singlemode, Armoured , unarmoured, indoor ) , the number of cores to be used (4 core fiber , 6 core fiber or more) and the route ( underground, overhead, through conveyer belt etc ) for laying, They also consider whether to use Fiber media converter ( 100 Mbps, Gigabit converter, Singlemode and Multimode) or Switches with SFP Fiber Gigabit modules. They also design the size of communication racks required at each location. Finally the network design and Bill of Material will be prepared
Once the design part is over our installation team will install the Fiber network. Our team will take care of the trenching and refilling of soft/ hard soil and road cutting within the campus. After the Fiber cabling is complete, our fiber specialist will do the Termination / Splicing. The Media Converters and Switches will be installed, configured and tested. The network will be documented for the support personnel.
Our engineer will visit the customer site and discuss with concerned executive the locations to be connected, the data transfer rate required. He will find out the criticality and any backup links required. From the feedback received from the engineer we design the Modems, Interface Converters and Routers. We install and configure the required networking products for the above connections and the process is documented for the support personnel.
Our engineer will visit the customer site and discuss with concerned executive the locations to be connected, the data transfer rate required. Then he will do the wireless site survey, check the line of sight and will take the GPS measurements. From the above testing the tower height, type of antenna and networking products to be used at each locations will be decided. Our installation team will install and configure the required wireless networking products.